It is strictly forbidden to modify the structure and circuit of the standby generator natural gas without permission, and it is forbidden for untrained personnel to operate the equipment, which may cause danger to life! Ensure that the air intake system is airtight and does not leak. Clean or replace the air filter element in time according to the usage of the filter. It should be replaced in time when it fails. To ensure the tightness of the natural gas supply system, clean or replace the high-pressure filter, the high-pressure solenoid valve and the filter element in the high-pressure reducer in time according to the daily maintenance situation. Ensure that the high-quality natural gas special lubricating oil and oil filter are regularly replaced according to the requirements of the instruction manual, and the oil should be added strictly according to the marking line of the oil dipstick, not too little or too much. Make sure to use high-quality antifreeze coolant according to the requirements of the instruction manual, and do not use natural water directly. Do not open the radiator cap when the engine is hot to prevent burns from the hot air. Make sure to use the gas that conforms to this model according to the requirements of the instruction manual. Before starting the engine each time, check the oil, coolant level, and the tightness of the air intake system. Ensure that the use, inspection, maintenance and repair are carried out according to the instruction manual. To prevent the wiring harness from being short-circuited, do not wash the engine wiring harness with water. If it is found that there is water in the connector part of the wiring harness, apply cold air to dry it before starting the engine. During welding, in order to prevent the welding current from burning out the engine ECU, the main power supply of the engine must be turned off, and the positive and negative terminals of the battery must be removed. For unknown questions and special circumstances, please ask Sichuan Rongteng after-sales service. We can provide 24-hour technical support and services in any form. The gas generator sets produced by Sichuan Rongteng mainly use CNG, LNG, biogas, and coalbed methane as fuel, and can be used in gas source places with methane content ≥ 20% according to the model: 1. Self-provided power supply: areas without municipal electricity network, oilfield drilling power, coal mines, farms; 2. Emergency power supply: if the enterprise produces standby emergency power supply; 3. Peak shaving power supply: make up for the lack of power supply from the municipal electricity network; 4. Mobile power supply: when the location of the power supply is constantly changing; When the gas tubine generator power rated at 0~100% & power factor COS Φ=0.8, the auto voltage adjusting frequency under 3 phase symmetrical load can meet the operation requirements, and it can be adjusted with the range of 95~105% of rated voltage when no load. When the genset operates under 3 phase asymmetrical load, if the phase current does not exceed the rated value and the three-phase current does not exceed more than 20%, then the genset is allowed to work for a long time. The gas powered generators unit complies with the national standard GB/T 33340-2016 safety design specification for reciprocating internal combustion gas generating units.   Contact us:   Sichuan Rongteng Automation Equipment Co., Ltd.   www. rtgastreat.com E-mail: sales01@rtgastreat.com Phone/whatsapp: +86 138 8076 0589